Videos are provided as a guide only. Ref...
Videos are provided as a guide only. Refer to manufacturer
installation instructions and specs for complete information.
Today on this 2006 Volvo S60 Sedan we are going to be installing part number 36297 from Draw-Tite. The first thing we need to do is remove the tow bracket on the passenger side of the vehicle. Keep a hold of the bolts, but put the tow bracket off to the side because we are going to be using the bolts for the installation. Now we are going to go to the driver side of the vehicle and lower down the exhaust bracket. We are also going to be putting our hitch in that position using the exhaust bracket bolts. :32
Now we are going to put our hitch into position using the bolts from the driver side exhaust bracket and the passenger side tow hook. You want to take the exhaust bracket and actually put it below the hitch so you are going to be pinching the hitch between the frame and the exhaust bracket itself. It is best to have an extra set of hands to help you maneuver around the exhaust as well. :55
With our bolts in position we want to go ahead and tighten and torque them down as specified in the instructions. We are going to take a few measurements for you to ensure the clearance for your hitch accessories. From the center of the hitch pin hole out to edge of the bumper is approximately 4 inches. From the ground to the top of the receiver tube opening is approximately 11 inches. This will complete the installation of part number 36297 on this 2006 Volvo S60 Sedan.