Build A 32 Plate 31 Cell Series HHO Electrolyzer Make Hydrogen F

Yes, its all off the shelf cheap stuff. Its only 4 inches, because I could not find a source for larger cpvc. On youtube there is a vid of a guy that took my idea and made a very small stacked cell in layers. Perfect for cars. Look up Scarecrow Labs on youtube. His efficiency is lower because of the holes passing power around the plates, but the size is great!

The cells can experience thermal run away. They hotter it get the more current it pulls. The more current it pulls the hotter it gets. So the most simple off the shelf solution is to limit current using capacitors. Caps will not pass DC (for long) so AC is needed to pass a limited amount of current through the cell via the capacitors. Simple, off the shelf, cheap.

There are no wires or connections inside the cell. Isolated series cells. Power applied only at the end plates. Also, AC or pulsed power is better because it lets the gas escape some between pulses and therefore there is less free ions to move current on each pulse. Rectified 60 hz power yields 120 hz pules. If wired directly to a car battery then internal wiring would be needed.

Duplicate all you want. Its a commercial design used by any good commercial torch system. It was developed un-patented my eagle-research.com Though I'm sure he was not the first to use a series cell design.

Also you must adjust your car computer to get the mileage otherwise it compensates for the cleaner burn by adding more gas. Methods include offsetting the oxygen sensor voltage in the + direction and adding resistance to the MAP sensor. Then the computer cuts back gas injected and S**ks more air.

I know this is main key in fuel saving. please advise more detail. ( is it changing computer reading value, or use 02 enhancer fool the computer on O2? )
please advise.
as many of you should know, without adjusting them, it will make clean burn(gas is fully burned), and the o2 feed back to the computer, it will send more gas to engine, and it only create around 10% -15% of fuel saving, but the extra gas that sent to engine was wasted. and don't want to come around and face o2 sensor problem later.


by the way, you inject the HHO into the gas pipe or air pipe?

Doubling my millage was more that achieved. I had to also inject water vapor to prevent pinging.

You can not run a engine by standard electrolysis using current from the car altenator. The BTU value of the gas is low and would require HUGE amounts of gas. The hydrogen is just something to light the gas. It causes turblance when it burns, mixing the gas/air mixture at over 800 feet per second.. Its kind of like throwing lighter fluid on wood. The easy burning substance gets the slower burning stuff lit and going. Well, that my theory anyway.

The hydrogen should prevent pinging... you may need to adjust the timing. Keep in mind the burn efficiency of the hydrogen is much greater than gasoline alone and mixing the two together changes the burn cycle of the gasoline in your engine.

no, not really, unless you generate it from grid power and use a scuba compressor to pressure up a bottle, then use the bottle to run the gocart.

You couldn't use that to power a generator, unless you were getting your energy from an outside energy source i.e. Solar energy or Harnessing wind energy.

If you have an power plant that runs on gasoline you can replace the gasoline with the HHO. I did on mine and Im powering my house with it. Trust me you can do many many MANNY things with the HHO. At least im not paying any electrical bill, and the electry company is pissed off at me because of it. And im trying to figure out other ways you could use it. Also I have a gas stove conected to an electrolyzer and I cook on it. The possibiltys are endless.

Your Comment Made None

You can light it, put it your car, melt metals, sniff it, blow up balloons.. What ever you want... Check my other vidoes too..