Blade 400 3D Tailsetup Part 2B

Tags:
3D 400 Blade
sokal11
  • Affiliate Submitter:
    sokal11
  • International International
  • Comments: 0
  • Views: 143
  • Added: 05-May-08

Blade 400 3d tail rotor build up

  1. Categories: N/A
  2. Favorite On: braddock
Comments on

Blade 400 3D Tailsetup Part 2B

4 Comments | Add Comment
  • yes this is normal ...

    yes this is normal
    due to each blade can not be made the same
    so you have to do what they call rotor smoothing or make the blades fly in the same path to do so you have to use one blade as refrance and adj the other to fly in the same plane yes the baldes wont match in pitch but its most likely to me less then a degree of

    if they are more than a degree do a blade balancing to help more

    By sokal11 [Affiliate User] 1212402547 Reply Spam Moderate Up Moderate Down
  • yes i was a bit ...

    yes i was a bit hasty with that comment i had a couple of beers which made it look even blurier.I appreciate all your vids they are a great help to all us b400 owners, keep up the good work.
    Im new to the rc world and only had mine a couple of months and have a question, If you set both rotors to 0 degree pitch at half stick shouldn't the blades be in track ? i find that mine arnt therefore have to use the same linkage to get the blades to track which means one blade is no longer at 0 degrees?

    By KicKsterTreX [Affiliate User] 1212377482 Reply Spam Moderate Up Moderate Down
  • yes i know i have ...

    yes i know i have poor equipment but i gave up my time to help others
    another freind is going to help me revise with much better equipment
    i have them posted else were with a better resolution the what youtube allows

    By sokal11 [Affiliate User] 1212306790 Reply Spam Moderate Up Moderate Down
  • might of been a ...

    might of been a good vid but all i can see is a blurry mess

    By KicKsterTreX [Affiliate User] 1212175978 Reply Spam Moderate Up Moderate Down
4 Comments | Add Comment