Free Energy Step By Step Instuctions Part 1

As you well know, the burden of proof rests with you to explain how your setup works. Please tell us about it, including your measurements that you claim indicate over-unity.

"you can't say something doesn't work just because you're just too clumsy to work it."

See above about the burden stuff. I'm not the one that's mad but there is indeed an aggressive edge to your prose. I am a bit clumsy, I can't ski, but I can solder quite well or work a frequency or logic analyzer just fine thank you.

Your just mad because you're unable to do it. Right? Mine works just fine, made mine a different way but just saying; you can't say something doesn't work just because you're just too clumsy to work it.

"COE > 1 means we get out more energy in form of electricity than we put in. As simple as that."

That sounds fine to me. Unfortunately it is not that simple. There is not a single example on YouTube or anywhere else for that matter that demonstrates more electrical energy out than goes in.

"these clips answer only questions about why these devices aren't widespread."

The clips answer no such questions. They aren't widespread because the devices don't work and don't exist.

Emm, these clips answer only questions about why these devices aren't widespread. About heat pum COE - yeah, that is bullshit.

Yet, COE in these systems have no connection with heat. It is COE of electricity, not heat. It is - COE > 1 means we get out more energy in form of electricity than we put in. As simple as that.

TehnomanX,

On one of Imhotep's more popular videos I state two methodologies for proving if free energy exists or not. The concepts are simple and easily understandable. Unfortunately no poster on YouTube has ever met the criteria that I mention for proving or disproving free energy. Forget about COE, everybody knows that a heat pump S**ks or puts heat into the ground in your back yard.

I have looked at the clips that you mention and unfortunately they say nothing of any relevance.

Thank you for showing the way.

between 3:15 - 3:40 you state that you need to seperate the 2 wires then place one back onto the rod. you think you could be a bit more specific? I mean there is 3 rods and 2 loose wires, which one am I suppose to attach, and to which rod?

and at 3:24 you show a step that says "inside start of wrap" what is that supposed to mean?
It would be great if you could make these things a bit clearer.

Drevtoob

Information is out there and these principles are proven quite well and by quite many. COE (coefficent of effeciency) > 1 is not rare! ;) The problem is that the development of such "free-energy" devices are being slowed down. I suggest to find and wach a film called "TESLA - Free Energy, the Race to Zero Point (Physics, Supressed Technology)". Can give answers to many questions! ;)

if you look in the information box on the right there is a link that takes you right there

...and where is the forum??

2k ohm ,any potentiometer will work

go to the forum and highly detailed explanations can be found there, i could only show so much in the movie

i have used many methods (gently heat with hair dryer, be cautious, gently grip with soft jaw pliers etc. some are glued softening with heat works. if you read through the forums you will see even the most advanced of us had issues, dont worry about it. take your time and read through the thread to get other ideas

that looked very complicated i could not understand your instructions.
the part where you mention various coil layouts

and another question (i'm noob in electronics.. please don't laugh) .. how did you remove the stator ? i think the stator from my fan is glued up and i can't remove it...