Crob227's Spiral Plate Cell Ultrasonic Gas Volume Test

maybe pipe the liquid away from the plates,and sonicate there,so the waves from the transducer arent impinging on the plates

I did try similar a couple years ago. Problem I was fighting was bubble accumulation on plates. Tried ultrasonics to keep plates clear. But when it did not increase production I dropped it due to complexity. I am looking at it again because my latests setup creates huge quantiy of fast moving nano bubbles. Am thinking this might help to get them out of solution. We shall see.

I think you should continue your research on this as you are correct in your primary thinking on this technology.

Thnax for that info.
it appears that ultrasonics will disassociate water without any voltage across the cell.This worked best when a standing wave was set up between the cell and the transducer.However the volumes i saw were to small to test.What do you think SGiHunter?

However, if you pulse this Cell with DC and tune the frequency to match the Ultrasonic unit you will have better results. Not an easy task as the Ultrasonic unit has a very complex frequency set.

aka IronHead

Ultrasonic Fogger is interfering with the electromagnetic wave in the Cell that disassociates the water molecule.I have done all kinds of test with sound and radio waves and found in the ultrasonic range this fact.

you used a very similar why to get by base line readings keep up the hard work cheers!

ultrasonics under the cell:20mL/25.30 sec
ultrasonics off :20mL/21.79 sec

ok i will try this-keep in mind that the cell has a void in the centre-and that is about the same size as the transducer-so the plates should shake more from the side-ultrasonics does separate water tho...see previous vid

i think Ultrasonic fogger should be under the fuel cell.