Metacafe Header Takeover

Home Built CNC Router

Tags:
CNC Mill Router 7th Sojourn Kleinbauer DIY Mach3 HobbyCNC
aolshove
  • Affiliate Submitter:
    aolshove
  • International International
  • Comments: 0
  • Views: 293
  • Added: 18-Sep-07

Home built CNC Router constructed from plans by Kleinbauer. Planset is "7th Sojourn" cutting out a "No Soliciting" sign for a friend. 30ipm 1/8" end mill, 1/16" end mill, 1/16" ball mill. 2D pocket/contour followed by a 2.5D relief cut.

  1. Categories: How To
Comments on

Home Built CNC Router

5 Comments | Add Comment
  • Thanks! Took about ...

    Thanks! Took about 40 hours and around 300 bucks. The most expensive parts are the controller board and the stepper motors.

    By aolshove [Affiliate User] 1214350260 Reply Spam Moderate Up Moderate Down
  • Nice! I am ...

    Nice!

    I am thinking about building one of these. How long did it take and how much did the hardware/software cost?

    By YTRocketMan [Affiliate User] 1214275108 Reply Spam Moderate Up Moderate Down
  • Nice machine. Are ...

    Nice machine. Are you not going to shield off does bearings on your moving table? They are rolling on the chips.

    By Nhyf [Affiliate User] 1211659794 Reply Spam Moderate Up Moderate Down
  • I would sure like ...

    I would sure like you to make a video about your Machine. Show us what motors, screws, rails, and so on. You seem to have a great knack for this.
    Thank You

    By Radcnc [Affiliate User] 1210018321 Reply Spam Moderate Up Moderate Down
  • Yes, carbide.

    Yes, carbide.

    By aolshove [Affiliate User] 1207320307 Reply Spam Moderate Up Moderate Down
5 Comments | Add Comment