#54 Tall HHO Bubbler Construction Details

It's tricky doing it that way though. Now that I have an actual tap for the job (a whopping $7) I'll never go back.

(re: skagitt post)

I like your threading method!

I recently read a safety test on a cell that used a cling-wrap diaphram as a burst disk.
The cell was ignited and the plexi case shattered. The diaphram was still intact. The test suggested that the cell was shattered by the sonic wave front rather than over-pressuring. I would use a check valve in the output line and call it good. If you did pop a cell located under the hood, it probably wouldn't cause much havoc.

to help with the water from going into the pump look up plast-o-matic they have a valve that closes off when whater hits it, but lets the gas out! also where can i get a pump like your, what is it called?

I've thought of a bubbler that uses the electrolyte fluid.
Place a tube on top, and one on bottom of 4" production tube. Top hole gas tube feeds around then to just above the bubbler tubes lower fill tube off of 4" main pipe. Bubbler is larger then gas hose to allow fluid to balance and display amount of electrolyte level in main tube. Top of bubbler feeds HHO to engine. Make sense? i'll try and make a video if needed.

Hey, that's a good idea. I'll try a safety release like that. Thanks.

Actually, shortly after producing this video I went out and spent $7 on a 1/4" NPT tap.

Very cool....wish I saw this a few months ago. I went out and bought a complete Tap and Die set. This is expensive! I've spent enough on this project to put 25 tanks of gas in my truck!!! But this is more fun!

I have a system running on my truck with no bubbler and no problem. There is so much vacuum on the cell from my v8 that it seems to consume the hydrogen as fast as it is produced. I do have a safety in my cell though, the bottom is a rubber end cap with a large hose clamp to seal. If it blows the bottom should come off with minimal damage. I never have backfires or problems relating to this therefore decided that the bubbler just complicates the process.

Thank you VERY much, sir! I've been shopping for a few odds and ends to complete another cell experiment involving pwm resonance as well as move into plasma fusion.

Contribution sent by PayPal.
More to come when I can afford.
Keep up the good work.

What kind of pressure or how many PSI's is the PVC able to take ? To run a car on HHO only you probably have to buffer the gas into a small presurized tank. How many liters/minute of HHO gas is needed to run a car 100% without any aditional fossil fuels ? Great stuff ! Keep up the good work !

Hello Does anyone ever ask about the newer cars with MAP devices and how they react to this fuel added to the system?

Stainless steel wool only.