Metacafe Header Takeover

Newman Motor Replication- Build 2/ Induction Generator

Tags:
DC Energy Free Generator Motors Newman Overunity Power Replication
TheB3e
  • Affiliate Submitter:
    TheB3e
  • International International
  • Comments: 0
  • Views: 1,022
  • Added: 16-May-08

I thought I would try and recapture some of the mechanical energy going to waste while I play around with this Newman motor.
By adding a type of crude induction generator on the end of the newman motor axle. The Generator is made of 6 coils of 200 turns each, wired in a clockwise/counterclockwise configuration. I flush mounted 6 round neo magnets with opposite poles facing the coils on a wheel made from a 4" PVC end cap.
Now keep in mind, the goal of this project is not this generator (much bigger gains to be had at the main coil)
But since the motor is spinning anyway, why not right?

With this setup I'm able to recapture 2V-3.5V DC with a 6V DC input
So now this motor has 1 input and 2 outputs.
Input: 4-1.5V AA Batteries (6V)
Output #1: Up To 14V DC (Main Coil)
Output #2: Up To 3.5V DC (Generator)

Just with the generator end, I was able to power up a small DC motor, various LED's, will try a cell phone next.. lol

  1. Categories: Science & Tech
Comments on

Newman Motor Replication- Build 2/ Induction Generator

6 Comments | Add Comment
  • where can i buy the ...

    where can i buy the magnets pls tell me

    By UzumakiYodaime [Affiliate User] 1225556206 Reply Spam Moderate Up Moderate Down
  • I will give it a ...

    I will give it a shot! May as well if it works because it the actual magnets that are spinning so the additional weight of thicker wire would not add any extra load in my case.. Thanks for the tip!

    By TheB3e [Affiliate User] 1211582983 Reply Spam Moderate Up Moderate Down
  • What do you think ...

    What do you think happens if you use the same number of turns of thicker wire for the generator coil? Surely that would generate more current for a given turn of a magnet than using thinner wire for the generator coil.

    By kmarinas86 [Affiliate User] 1211519931 Reply Spam Moderate Up Moderate Down
  • Build a newman ...

    Build a newman machine with a generator coil over that an you will see that you dont need a generator... look my videos STARK

    By armakuni2000 [Affiliate User] 1211510031 Reply Spam Moderate Up Moderate Down
  • The coils are ...

    The coils are hooked up in series at the moment. If you look from the top down they would be wired in a clockwise to counterclockwise configuration. I may take them off to try and lighten the load a bit while I play with the back emf from the main coil. Im reading some pretty interesting voltages coming out of it but have yet been able to get the current up..

    By TheB3e [Affiliate User] 1211505406 Reply Spam Moderate Up Moderate Down
  • are the coils ...

    are the coils hooked in parallel or series?

    By uusedman [Affiliate User] 1211042147 Reply Spam Moderate Up Moderate Down
6 Comments | Add Comment