Metacafe Header Takeover

HHO Electrolyzer Cap Assembly Water4gas 2 of 3

Tags:
Build Cap Electrolyzer HHO Make Water4gas With
mikejetmore
  • Affiliate Submitter:
    mikejetmore
  • International International
  • Comments: 0
  • Views: 2,142
  • Added: 11-Jun-08

Making the cap for the water4gas HHO electrolyzer. Gluing the parts together (bubbler, one way valve, contacts)

  1. Categories: Wheels & Wings, How To
  2. Favorite On: willyb62 sealtite88 casehydro nessiebreton founder3
Comments on

HHO Electrolyzer Cap Assembly Water4gas 2 of 3

9 Comments | Add Comment
  • where did u get the ...

    where did u get the one way check valve or pop off. nice instructional

    By jrcortz [Affiliate User] 1215367298 Reply Spam Moderate Up Moderate Down
  • Where do you get ...

    Where do you get the stainless steel wire? I cant find it cheap enough around my home town.

    By STUDENTOFARNIS [Affiliate User] 1214813832 Reply Spam Moderate Up Moderate Down
  • good job on the vid ...

    good job on the vid. between you and the water4gas e book, I built my hho gen in no time.

    By jimisdad [Affiliate User] 1214800040 Reply Spam Moderate Up Moderate Down
  • Bubblers can be ...

    Bubblers can be found at Ace, Home Depot, or any irrigation supply. The are for drip irrigation. Shouldn't be more than $1 each.

    By mikejetmore [Affiliate User] 1214557464 Reply Spam Moderate Up Moderate Down
  • Does anyone know ...

    Does anyone know where to get the vacuum adjustment valve/drip bubbler? I've got everything ready except for this. Please let me know.

    By tigr7170 [Affiliate User] 1214509176 Reply Spam Moderate Up Moderate Down
  • We've been ...

    We've been discussing if that is actually necessary. When hooked up to a vehicle, it is pulling a vacuum on the container. The idea is that you can adjust an airflow thru the container. However, most of what I've been studying says that when producing HHO its better to close the bubbler completely. I'm also considering increasing the output hose side to 3/8" and eliminating the 1way valve as well. That would simplify the cap to just 3 holes - 2 power post and the output elbow.

    By mikejetmore [Affiliate User] 1214403168 Reply Spam Moderate Up Moderate Down
  • what is the Bubber ...

    what is the Bubber part for? :S

    By harpersteven [Affiliate User] 1214397199 Reply Spam Moderate Up Moderate Down
  • Nice. Does anybody ...

    Nice. Does anybody know where to get the bubbler cap (vacuum adjustment valve)from?

    By meadjodha [Affiliate User] 1213790471 Reply Spam Moderate Up Moderate Down
  • Very Nice Mike!!! ...

    Very Nice Mike!!!
    I am running a different version on my van, and find that engine power increases and that the engine does run smother and quieter then normal. I am still determining if MPH has improved because I have not run a whole tank of gas out as of yet. However, seems to me that MPH has improved. I notice more power with less RPMs then normal. You may want to add your water4gas hop link, so that your viewers will be able to find the water4gas info. You may use mine if needed.
    Dave

    By A1Powers [Affiliate User] 1213615846 Reply Spam Moderate Up Moderate Down
9 Comments | Add Comment