DIY Red Laser

Tags:
DIY Lasers
oWhyBother
  • Affiliate Submitter:
    oWhyBother
  • International International
  • Comments: 0
  • Views: 1,572
  • Added: 12-Dec-07

This is my DIY laser. Uses a laser diode made for a 16x dvd burner and a L.E.D flashlight from target.

Also I had just finished it and was testing.

  1. Categories: Science & Tech
  2. Favorite On: blackcatt_pt100
Comments on

DIY Red Laser

4 Comments | Add Comment
  • No it works just ...

    No it works just fine. I use nimh because they are more stable. Fresh alks will blow the diode in seconds if not instantly. That is why you do not use alkaline. :)

    By oWhyBother [Affiliate User] 1202688239 Reply Spam Moderate Up Moderate Down
  • ifu have it ...

    ifu have it directly hooked 2 AAAs batt ur going to kill ur diode

    By kasjv [Affiliate User] 1202531854 Reply Spam Moderate Up Moderate Down
  • I was using the ...

    I was using the driver that came with the LED Flashlight, 150ma at 3v. It made about 80mw then. I have recently striped the driver board and connected the diode directly the the 2 AAAs. They give 260 to 215mA at 3.2v with output around 145 to 120mw.

    I will try and get around to uploading new videos.

    By oWhyBother [Affiliate User] 1201226901 Reply Spam Moderate Up Moderate Down
  • hi your video was ...

    hi your video was great, what driver did you use to run that and (mA0 for that? what is your input power for that? what was the output power of your DVD burner laser (mW)?

    By adgmlaser [Affiliate User] 1201221595 Reply Spam Moderate Up Moderate Down
4 Comments | Add Comment